Mikrotik loopback ip address11/22/2023 ![]() ![]() I cloned existing Contoso Web server, then changed its IP address to 192.168.17.17 and altered the content of its only Web page. I added one more VM – Contoso Intranet server.I made two changes for a better simulation: So yes, you can see those new IPSec configuration screens. The Contoso router is now on the RouterOS version 6.44.5. I will again use the Trange-Frange Company (TFComp) router and Contoso router/LAN. You have been warned! A few important notes about this simulation In case that VPN or encryption technologies are considered forbidden and/or illegal in your country, please stop further reading and leave this page. Let’s begin!īefore we begin, I need to write a word of caution. This scenario is different than other one described in this article where MikroTik is behind another router, as in this case our MikroTik has a WAN port (like a 3G/4G-LTE or cable modem) with the dynamic IP address, plus there’s a good chance that this address is from the ISP’s private IP address pool.Įven better, in this article I will explain you the concept of a Loopback adapter and how you can use it in situations similar to this one. Various other trademarks are held by their respective owners.In this part of the MikroTik IPSec series, I will show you how to establish a Site to Site IPSec tunnel between two routers, when one of them has a dynamic WAN IP address. WatchGuard and the WatchGuard logo are registered trademarks or trademarks of WatchGuard Technologies in the United States and other countries. The public IP address that users want to connect to is 203.0.113.5. The NAT loopback policy in Fireware Web UI The NAT loopback policy in Policy Manager ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |